Panasonic AG-DVC30P Service Manual page 188

2. Connect the 2 pcs. of 30 pin flat cables (VFK1317) between P101/P102 on the Measuring Board (VFK1308P),
and 2 connectors on the EVR Connector Board (VFK1309A). Make sure that the contact surface of 2 pcs. of 30
pin Flat Cables are inner side and direction of the EVR Connector Board is as shown in Figure. Then connect
the Connection Adapter (VFK1763).
Connect VFK1763 with VFK1309A as
shown in picture.
If the connector is attached backward,
it will not work.
3. Connect the Connection Adapter (VFK1763) to EVR connector in Unit. Then make sure that the direction of the
VFK1309A and VFK1763 are correct as shown in Figure.
When the VFK1763 is connected
to EVR connector, be careful of
the direction of
Please follow as shown in the
figure.
5-2-2. Setting item for LISTA Measurement (Only VCR mode)
ATF GAIN
To confirm the ATF sensitivity, change the tape speed.
By pressing MULTI-DIAL button, enter the adjustment mode and then exit the menu once. The VTR mode is
operated when the menu mode is exited temporarily. The screen below is displayed.
NOW SERVO ADJUST
PUSH MENU TO RETURN
It will be returned to ADJUST MENU when the MENU key is pressed in this condition.
LINEARITY
To confirm the LINEARITY, change the ATF sensitivity.
By pressing MULTI-DIAL button, enter the adjustment mode and then exit the menu once. The VTR mode is
operated when the menu mode is exited temporarily. The screen below is displayed.
NOW SERVO ADJUST
PUSH MENU TO RETURN
It will be returned to ADJUST MENU when the MENU key is pressed in this condition.
NOTE: ATF GAIN and LINEARITY can not be selected on CAMERA mode.
VFK1309A.
Part side
VFK1763
Connect the
VFK1763
INF-13
VFK1309A
30 pin Flat Cable
VFK1308P