Panasonic AG-DVC30P Service Manual page 52

12. Removal of LCD Unit
1. Remove the MIC Case Unit.
2. Remove the Side Case R Unit.
3. Unscrew the 3 screws (A) and remove the HEAT SINK(SIDE R) as shown in figure 12-1.
4. Remove the FFC Protection Sheet as shown in figure 12-2.
5. Remove the Cooling Sheet to unscrew the screw (B) and unscrew the screw (B) and (C) as shown in figure
12-2.
6. Remove the HINGE COVER and unscrew the 2 screws (D) as shown in figure 12-3.
7. Disconnect connector P6404 on R SIDE C.B.A. and remove the LCD Unit as shown in figure 12-2.
(Note in installation)
1. When installing the FFC Protection Sheet, fully open the LCD Panel and Put on the original position as shown
in figure 12-2.
2. Do not forget put on the Cooling Sheet after tightening the screw (B) as shown in figure 12-2.
HEAT SINK (SIDE R)
SCREW (A)
FFC Protection Sheet
P6404
SCREW (D)
SCREW (A)
Figure 12-1
Cooling Sheet
SCREW (B)
Figure 12-2
HINGE COVER
Figure 12-3
DIS-12
SCREW (C)
LCD PANEL UNIT