Panasonic AG-DVC30P Service Manual page 44

5. Removal of POWER C.B.A.
1. Remove the MIC Case Unit.
2. Remove the Side case R Unit.
3. Disconnect a connector P1001 on POWER C.B.A. as shown in figure 5-1.
4. Unscrew the 2 screws (A) and remove the POWER C.B.A.. Be careful because the CAMERA C.B.A.(bottom
side of POWER C.B.A.) and the connector in the POWER C.B.A are combining the one connector.
(Note in installation)
1. In case new POWER C.B.A. is installed, put the Cooling Sheet in following position as shown in figure 5-1.
COOLING SHEET
POWER C.B.A.
P1001
Figure 5-1
DIS-4
SCREW (A)
There is a direct connector in
the backward.
COOLING SHEET
(Two sheet)
SCREW (A)