Panasonic AG-DVC30P Service Manual page 48

9. Removal of Rear Case Unit & CAMERA C.B.A.
1. Removal of MIC Case Unit.
2. Removal of Side Case R Unit.
3. Removal of POWER C.B.A..
4. Removal of TOP VF Unit.
5. Removal of Front Case Unit.
6. Removal of Lens Unit.
7. Remove the 3 screws (A) as shown in figure 9-1.
8. Disconnect a connector P2 on CAMERA C.B.A. as shown in figure 9-1.
9. Unscrew the 2 screws (B) on CAMERA C.B.A. as shown in figure 9-1.
10. It shifts the Rear Case Unit as much as showing in figure 9-1 and remove the CAMERA C.B.A.. Be careful
because the VTR C.B.A.(bottom side of CAMERA C.B.A.) and the connector in the CAMERA C.B.A are
combined.
11. Disconnect a connector P2216 on VTR C.B.A. and remove the Rear Case Unit.
(Note in installation)
1. When installing the CAMERA C.B.A., Attach the CAMERA C.B.A. to portion "A" of Mech. Attachment Frame
as shown in figure 9-1.
2. When installing the CAMERA C.B.A., the parts which are shown in figure 9-1 on the CAMERA C.B.A. are
combined with the VTR C.B.A. with the direct connector, pushing CAMERA C.B.A. well.
3. When installing the Rear Case Unit, it puts section "B" in the hole of flexible cable, which is connected in
P2216 as shown in figure 9-1.
There is a direct connector in
the bottom and push well.
CAMERA C.B.A
Hook to Frame.
SCREW (B)
A
P2216
Figure 9-1
DIS-8
P2
REAR CASE UNIT
SCREW (A)
SCREW (A)
SCREW (A)
B