Table of Contents
Advertisement
2.1. Control Panel
Message Display
The message display gives information in the form of short messages. The seven messages
listed below are displayed during normal warm-up and printing.
Message
6HOIý WHVW
3OHDVHý ZDLW
5HDG\
3URFHVVLQJ
:DLWLQJ
6OHHSLQJ
)RUP)HHG
7LPH2XW
Other messages appear when the printer needs the operator's attention as explained in
Chapter 5.
Interface Indicator
The interface indicator shows which of the printer's interfaces is currently active. It uses
the following abbreviations:
3$5
6(5
23ì
23ë
Theý3$5,ý6(5,ý23ì, orý23ë indicator flashes when the printer is receiving and has
received all the data, and then remains on. The printer gives priority to data coming in over
the interface corresponding to the blinking indicator.
Resolution Indicator
This shows the current printing resolution. The default is 600 dpi (dots-per-inch) in the PCL
6 and KPDL emulation mode and 300 dpi in other emulation modes. The printer's resolution
can be selected using the printer's control panel. (See the last page in this manual.)
2-2
The printer is self-testing after power-up.
The printer is warming up and is not ready.
The printer is ready to print.
The printer is receiving data, generating graphics, reading an memory
card, or printing.
The printer is waiting for a command that says the job is over before
printing the last page. Pressing the FORM FEED key allows you to obtain
the last page immediately.
The printer is in Sleep mode. The printer wakes from Sleep mode
whenever a key on the control panel is pressed, the cover is opened or
closed, or data is received. The printer then warms up and goes online.
(The time that it takes the printer to enter Sleep mode depends on the
Sleep Timer setting.)
The printer prints the last page after a waiting period.
Standard bi-directional parallel interface
Serial interface (RS-232C/RS-422A)
Optional interface 1
Optional interface 2
Meaning
Advertisement
Table of Contents
