Table of Contents
Advertisement
Field Name
RSRP1 ~ RSRP4
WAN Throughputs
DL
UL
Average
Peak
Sum
Device Health
CPU Usage
Memory Usage
USIM Status
Connection State
IMSI
System Up Time
LTE/NR
Connection Time
Firmware Version
Firmware Build
Time
Hardware Version
Module Version
Diagnosis
Ping
Traceroute
Ping Watchdog
WAN Connections
Profile Name
IPv4 Address/ IPv6
Address
The Signal-to-Interference-plus-Noise Ratio reflects the signal
strength of the signal received from the two antennas in the eNB,
expressed in decibels (dB)
NOTE: Additional SINR values are reported when a transmitting
device is using more than two antennas.
The current downlink data throughput rate, in Kbps
The current uplink data throughput rate, in Kbps
The average DL and UL data throughput rates, in Kbps, for this CPE
in the last 3 minutes
The peak DL and UL data throughput rates, in Kbps, for this CPE in
the last 3 minutes
The total (sum) DL and UL data throughput rates, in Kbps
CPU real-time usage rate, updated every 3s
The memory usage rate of CPE, updated every 3s
The Universal Subscriber Identity Module, or SIM, card status is
either available or not ready in the CPE
Connection status between the CPE and the network –Checking
SIM, Scanning, Registering, Acquiring IP, Connected,
Disconnected.
The unique International Mobile Subscriber Identity (IMSI) number
associated with the SIM card in the subscriber's CPE. The IMSI
must be identifiable by the operator's LTE network in order to access
it.
CPE start time
LTE/NR network access success time
Version number of the module
Software version compilation time
CPE hardware version
CPE LTE module firmware version
Ping diagnosis results
Traceroute diagnosis results
Ping Watchdog configuration result
APN Number
IPv4or IPv6 address of the APN gateway
Description
Advertisement
Table of Contents
