Table of Contents
Advertisement
3.6.13.1
Ping
Ping is used to manually initiate a ping test to check connection status. Running a ping
test will send data packets of a specified size from the CPE over the network to a target
IP address. The results of ping determine if there is a connection and if there is any
packet loss.
Figure 3-60 Ping Diagnosis Settings
Table 3-12 Ping Diagnosis parameters
Field Name
Description
Target IP
A target IP address for the CPE to ping
Interface
The interface the CPE should use, either DEFAULT (APN1) or APN 2,
3, or 4.
Package Size
The data packet size to be sent to the target IP address, in bytes. The
range is 1-9000 bytes.
Timeout
A timeout period, in seconds. The range is 1-10 seconds.
Count
The number of times (Count) for the ping test to execute. The range is
1-10.
3.6.13.2
Trace Route
Running a traceroute test will display the route a packet takes from the CPE to a target
IP address. The test provides an indication of where there may be delays in the
transmission of packets across the IP network.
Advertisement
Table of Contents
