Table of Contents
Advertisement
To back up current settings, click the GENERATE ARCHIVE button.
To restore configuration files, select backed up file on your computer, and then click the
UPLOAD ARCHIVE button.
3.6.8.2 Update Firmware
Caution: Do not power off the CPE or disconnect it from the computer during an upgrade.
To update (upgrade) the CPE to a different firmware version (Figure 3-50):
1. Download the image file from the Baicells support website (Baicells > Support >
Downloads), and save it to your computer.
2. Under Flash new firmware image, determine if you want to keep the current
configuration settings on the CPE. If you do, select the check box next to Keep
settings.
3. Click on Choose File to navigate to the new image file on your computer, and then
click on FLASH IMAGE to initiate the upgrade.
After the upgrade, the CPE will restart automatically running the newer version of code.
3.6.8.3 Update Firmware Module (Patch)
To upgrade a specific module, meaning to apply a patch to the current firmware (Figure
3-50):
1. Download the image file from the Baicells support website (Baicells > Support >
Downloads), and save it to your computer.
2. Under Module upgrade, click on Choose File and navigate to the new module image
file.
3. Click on FLASH IMAGE to initiate the patch upgrade.
3.6.9 Ping Watchdog
Ping Watchdog is a feature used for detecting the Internet connection state of the CPE. If
the CPE cannot connect to the Internet, if this feature is enabled it will reset the LTE
module in the CPE firmware or reboot the CPE in an attempt to recover the connection.
To enable the watchdog function (Figure 3-51):
1. Select the check box next to Enable and enter an IP address accessible by Internet
for the CPE to try to ping.
Advertisement
Table of Contents
