Press The Enter Softkey - HP 54753A User Manual

Performing TDT Normalization
The purpose of this section is to show the process used to normalize a coaxial
cable for TDT measurements. The following procedure shows how to perform
TDT normalization.
1 Connect a 1 m SMA coaxial cable from channel 1 to channel 2 of the
TDR plug-in module.
2 Press the
STORAGE Setup
Press the
3 Default setup
4 Press TDR/TDT Setup
5 Press the Stimulus softkey and select
6 Press the
Enter
7 Press the TDT 1 dest
destination channel for the TDT measurements.
8 Press the Enter
9 Press the
Preset TDR/TDT
10 Press the SETUP Channel 2/4
11 Change the Offset
12 Press the
SETUP Time base
Establishing the Reference Plane and Normalizing
menu key located above the display.
softkey.
on the TDR plug-in module.
softkey.
softkey and select channel 2. This selects the
softkey.
softkey.
key.
to –50 mV.
key located below the display.
Single-ended TDR Measurements
( for the HP54753A) in.
1 only on
7-15