Other (Parallel Converter Cable) - Omron FHV7H-C004-H19-MC Hardware Setup Manual

l [Output]
Object signals:
• No.20 to 23 pins: Connect the COMOUT1 and COMIN0 terminals when using these signals.
a) Internal specifications for NPN connection
Item
Internal circuit dia-
gram
b) Internal specifications for PNP connection
Item
Internal circuit dia-
gram
6-1-4

Other (Parallel Converter Cable)

When you change to connect the F series, FZ5 series, or FZ5-L series to FH series Sensor Controller,
you can convert by using the appropriate parallel converter cable of FH-VPX series under the usable
condition.
Corresponding model
FZ£ series
FZ£-L35£ series
F160-C10
F160
series
F160-C10CP
F160-C10CF
F210-C10
F210
series
F210-C10-ETN
F500
F500-C10
series
F250 series
F270 series
*1. If the RESET signal becomes unavailable by conversion even though the signal has been used, but it caus-
es no problem, the conversion is possible by satisfying other required conditions.
FH Series Vision System Hardware Setup Manual (Z366-E1)
Con- Applicable parallel
vertible conversion cable
Yes FH-VPX-FZ
Yes FH-VPX-FZL
Yes FH-VPX-F160
No -
No -
Yes FH-VPX-F210
Yes FH-VPX-F210
Yes FH-VPX-F210
No -
No -
Specifications
COM IN
Load
+
Each output
terminal
COM OUT
Specifications
COM OUT
+
Each output
terminal
Load
COM IN
Required conditions
•
RESET is not used.
•
The same power supply is shared in
COMIN and COMOUT.
•
RESET is not used.
•
RESET is not used.
•
The same power supply is shared in
COMIN and COMOUT.
•
Do not use DI5 and DI6.
-
-
•
RESET is not used.
•
The same power supply is shared in
COMIN and COMOUT.
•
Do not use DI8 and DI9.
-
-
6 I/O Interface
6
*1
*1
*1
*1
6-19