Omron FHV7H-C004-H19-MC Hardware Setup Manual page 72

3 Configuration
Component Names and Functions
(F)
(H)
(G)
Connector name
(A) SD memory card
installation con-
nector
(B) USB2.0 connector Connects to USB 2.0. Do not plug or unplug it during measurement. Otherwise
(C) USB3.0 connector Connects to USB 3.0. Do not plug or unplug it during measurement. Otherwise
(D) Ethernet connec-
tor
(E) RS-232C connec-
tor
(F) Monitor connector
(G) I/O (Parallel) con-
nector (control
lines, data lines)
(H) Camera connec-
tor
(I) Power supply ter-
minal connector
3-14
(A)
(B)
(C)
(D)
(E)
(I)
Install the SD memory card. Do not plug or unplug the SD memory card during
measurement operation. Otherwise measurement time may be affected or data
may be destroyed.
measurement time may be affected or data may be destroyed.
measurement time may be affected or data may be destroyed.USB 3.0 has a
high ability to supply the bus power. Use the Sensor Controller by combining
USB 3.0, faster transport can be realized.
Connect an Ethernet device.Ethernet port, EtherNet/IP port, and PROFINET port
are sharing use.
Connect an external device such as a PLC.
Connect a monitor.
Connect the controller to external devices such as a sync sensor and PLC.
Connect cameras.
Connect a DC power supply. Wire the FH Sensor Controller independently on
other devices.
Wire the ground line. Be sure to ground the FH Sensor Controller alone.
Use an attachment power terminal (male) for installation. For details, refer to
5-3 Sensor Controller Installation on page 5-5.
FH Series Vision System Hardware Setup Manual (Z366-E1)
Description