Omron FHV7H-C004-H19-MC Hardware Setup Manual page 65

Component Names and Functions
(A)
(B)
(C)
(D)
(E)
(F)
Connector name
(A) SD memory card
installation con-
nector
(B) Ethernet connec-
tor
(C) USB connector
(D) RS-232C connec-
tor
(E) DVI-I connector
(F) I/O (Parallel) con-
nector (control
lines, data lines)
(G) EtherCAT address
setup volume
(H) EtherCAT commu-
nication connector
(IN)
FH Series Vision System Hardware Setup Manual (Z366-E1)
(G)
(H)
(I)
(J)
(K)
(L)
Install the SD memory card. Do not plug or unplug the SD memory card during
measurement operation. Otherwise measurement time may be affected or data
may be destroyed.
Connect an Ethernet device.
Upper port :
Ethernet port
Lower port :
Ethernet port, EtherNet/IP port, and PROFINET port are
sharing use.
Connect a USB device.
Do not plug or unplug it during measurement. Otherwise measurement time may
be affected or data may be destroyed.
Left ports: USB2.0
Right ports: USB3.0
The USB3.0 interface has a higher bus power supply
capability than the USB2.0 interface, and you can expect more
stable operation with it.
Also, when used in combination with a USB3.0 device, you can expect higher
transfer speed than USB2.0.
Be sure to give priority to using the USB3.0 interface.
Connect an external device such as a PLC.
Connect a monitor.
Connect the controller to external devices such as a sync sensor and PLC.
Used to set a station address (00 to 99) as an EtherCAT communication device.
Connect the opposed EtherCAT device.
3 Configuration
Description
3
3-7