Table of Contents
Advertisement
Parameter
Description
It specifies the interface that the access control rule applies to, including LAN and WAN.
LAN: The ONT checks traffic from the LAN side according to the rule and decides to pass
⚫
Interface
it or discard it.
WAN: The ONT checks traffic from the WAN side according to the rule and decides to
⚫
pass it or discard it.
Start IP Address
They specify the IP address range or a certain IP address that is controlled by the rule.
End IP Address
It specifies the protocol adopted by the traffic, or the types of traffic.
Any: It indicates that all types of traffic are under the control of this rule.
⚫
TELNET: Telnet is a protocol that provides a command line interface for communication
⚫
with a remote device or server, sometimes employed for remote management but also
for initial device setup like network hardware.
FTP: File Transfer Protocol (FTP) is a standard network protocol used for the transfer of
⚫
computer files between a client and server on a computer network.
TFTP: Trivial File Transfer Protocol (TFTP) is a simple file transfer protocol that allows a
⚫
client to get a file from or put a file onto a remote host.
HTTP: Hypertext Transfer Protocol (HTTP) is an application protocol and the foundation
⚫
ServiceName
of data communication for the World Wide Web, where hypertext documents include
hyperlinks to other resources that the user can easily access.
HTTPS: Hypertext Transfer Protocol Secure (HTTPS) is an extension of HTTP. SNMP is
⚫
used for secure communication over a computer network, and is widely used on the
Internet.
SNMP: Simple Network Management Protocol (SNMP) is the most widely used network
⚫
management protocol in TCP/IP networks, which enables you to remotely manage all
your network devices compliant with this protocol.
PING: Ping is a computer network administration software utility used to test the
⚫
reachability of a host on an IP network.
WAN/LAN
It specifies the interface to which the rule applies. It changes as you choose an interface.
ACL Table
It displays all the ACL rules that are added.
Select
It is used to select multiple ACL rules.
It specifies the control mode of the rule. If you deselect Enable when setting an ACL rule,
State
the State shows Disable.
Interface
It specifies the interface that the access control rule applies to, including LAN and WAN.
IP Address
It specifies the IP address range or a certain IP address that is controlled by the rule.
Services
It specifies the protocols adopted by the traffic, or the types of traffic.
Port
It specifies the default ports adopted by the corresponding services.
113
Admin
Advertisement
Table of Contents
