Tenda PON ONT HG9 User Manual page 76

Parameter description
Parameter Description
FilterDirection
It specifies the forwarding direction of data to be filtered.
Direction (HG6)
It specifies the default action for the outgoing(LAN WAN) or incoming(WAN LAN)
data.
Default Action
⚫
⚫
It specifies the protocol adopted by data to be filtered.
⚫
⚫
Protocol
⚫
⚫
⚫
It specifies whether to deny or allow the data to pass through.
⚫
Rule Action
⚫
It specifies the source IP address of the packets. The settings of Source IP Address and
Subnet Mask determine which computers are affected by this rule.
⚫
Source IP Address
⚫
⚫
Subnet Mask It specifies the subnet mask of the source IP address.
Deny: Denies traffic which does not match the filter rule in the Current Filter Table.
Allow: Allows traffic which does not match the filter rule in the Current Filter Table.
TCP: TCP protocol.
UDP: UDP protocol.
ICMP: ICMP protocol.
TCP/UDP: TCP protocol and UDP protocol.
ANY: Any protocol.
Deny: Packets that comply with the rule are denied, while others are perform the
default action.
Allow: Only packets that comply with the rule are allowed, while others are perform
the default action.
When Filtering Direction is set to LAN WAN, this parameter specifies the LAN
computer's IP address to be affected.
When Filtering Direction is set to WAN LAN, this parameter specifies the internet
computer's IP address to be affected.
When this parameter is left blank, all IP addresses are covered.
66
Services