Table of Contents
Advertisement
Installing a Barcode Reader
To install a barcode reader, you will need a #1 Phillips screwdriver.
To install a barcode reader:
1. Remove the magazine or magazine blank in the right magazine bay.
2. Power off the SuperLoader.
3. Remove the top cover of the SuperLoader. There are four screws in the back
4. In the barcode reader bay on top of the picker, a plastic blank protects the
Figure 85: Barcode reader bay location and screw
5. Pull straight up on blank to remove, then discard it.
1/16 Tape SuperLoader Reference Guide
Use of controls or adjustments or performance of procedures
WARNING:
other than those specified herein may result in hazardous radiation exposure.
and two screws in the front.
electronics. Loosen the screw attached to the blank.
2
1
Upgrading/Replacing CRUs
125
Advertisement
Table of Contents
