Sequential Mode Operation - HP StorageWorks 1/16 Tape SuperLoader Manual

Installation and Configuration
5. Do one of the following:
6. Reboot for the new mode to appear on the LCD.
The new control mode is now in effect.
Note:
SCSI bus.

Sequential Mode Operation

If you enable the Sequential control mode you must use the Sequential Ops
submenu under the Commands menu to operate the SuperLoader after it has been
rebooted.
To start Sequential Mode operation:
1. On the main menu, scroll to Commands.
2. Press Enter.
3. On the Commands submenu, scroll to Sequential Ops.
4. Press Enter.
5. On the Sequential Ops submenu, scroll to Start.
6. Press Enter. Moving first tape to drive is displayed.
To stop Sequential Mode operation:
1. On the main menu, scroll to Commands.
2. Press Enter.
3. On the Commands submenu, scroll to Sequential Ops.
28
To change the control mode, scroll to the desired mode and press Enter.
A checkmark appears. Press Enter again.
To leave the control mode unchanged, press Escape.
a. Press and hold the power button on the front panel until Power Off
appears on the LCD.
b. Press the power button again to power on the SuperLoader.
When you enable the Sequential mode, LUN 1 no longer appears on the
Start allows you to load the first cartridge.
Resume allows you to continue if the cycle was stopped.
Stop stops the cycle.
1/16 Tape SuperLoader Reference Guide