Table of Contents
Advertisement
Installation and Configuration
Preparation
Make sure that the work area is free from conditions that could cause electrostatic
discharge (ESD). See Appendix B, "Electrostatic Discharge," for additional
information. You will need a #2 Phillips screwdriver.
SCSI Bus Requirements
The SuperLoader contains a SCSI interface that supports both Single Ended (SE)
and Low Voltage Differential (LVD) communication. The SuperLoader is not
compatible with a High Voltage Differential (HVD) SCSI bus.
The following controllers are currently supported on the SuperLoader:
Your SCSI host adapter card must also support the SCSI bus type you use to
connect the SuperLoader. If you use a LVD SCSI bus, use a host adapter card that
supports LVD.
The following cables are shipped with your SuperLoader:
Note:
SCSI bus.
1/16 Tape SuperLoader Reference Guide
64-bit/66 MHz Dual Channel Wide Ultra3 SCSI adapter
64-bit/66 MHz Single Channel Wide Ultra 3 SCSI adapter
64-bit Dual Channel Wide Ultra2 SCSI adapter
68-pin VHDCI connector to 68-pin VHDCI connector
3 foot (.092 meter) cable
68-pin VHDCI connector to 68-pin VHDCI connector
6 foot (1.83 meter) cable
68-pin VHDCI connector to 68-pin HD connector 6 foot (1.83 meter) cable
Optimal performance will be attained when the interface is used as an LVD
2
9
Advertisement
Table of Contents
