Table of Contents
Advertisement
ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
5.4 FC100 (0x64) Read/Write Module Settings
This section describes all sub function calls (sub-FC) of FC100 (0x64) for the settings
on IR-310-RM. It is necessary to append 2 bytes of CRC16 to the tail of each Modbus
command.
Sub-FC
00 (0x00)
Read the module name.
03 (0x04)
Read the software Modbus address (Net ID) of the module.
04 (0x04)
Set the software Modbus address (Net ID) of the module.
05 (0x05)
Read the communication settings.
06 (0x06)
Set the communication settings.
07 (0x07)
Read module response delay time.
08 (0x08)
Set module response delay time.
32 (0x20)
Read the firmware version.
35 (0x23)
Read Power-on value/Power failure memory mode.
36 (0x24)
Set Power-on value/Power failure memory mode.
37 (0x25)
Read the latency for power failure memory.
38 (0x26)
Set the latency for power failure memory.
39 (0x27)
Read the preset power-on values.
40 (0x28)
Set the preset power-on values.
64 (0x40)
Read the time interval of the sequential mode.
65 (0x41)
Set the time interval of the sequential mode.
66 (0x42)
Read the independent/interlocked mode.
67 (0x43)
Set the independent/interlocked mode.
68 (0x44)
Read IR-relay-states.
69 (0x45)
Set IR-relay-states.
70 (0x46)
Read the source of IR sensor.
71 (0x47)
Set the source of IR sensor.
72 (0x48)
Read Non-sequential/Sequential mode.
74 (0x4A)
Read relay pairs for interlocked mode.
75 (0x4B)
Set relay pairs for interlocked mode.
76 (0x4C)
Read the DIP switch state
90 (0x5A)
Emit IR remote commands for the IR-310-RM.
91 (0x5B)
Set Forward/Backward sequential relay action.
IR-310-RM, IR Controlled 10-ch High Power Relay Module (Ver. 1.1, Jul/02/2013) 33
Table 5-2: Sub-FCs of FC100 for IR-310-RM
Description
Section
5.4.1
5.4.2
5.4.3
5.4.4
5.4.5
5.4.6
5.4.7
5.4.8
5.4.9
5.4.10
5.4.11
5.4.12
5.4.13
5.4.14
5.4.15
5.4.16
5.4.17
5.4.18
5.4.19
5.4.20
5.4.21
5.4.22
5.4.23
5.4.24
5.4.25
5.4.26
5.4.27
5.4.28
Advertisement
Table of Contents
