Communication Settings Section; Sequential Action For Relays Section - ICP DAS USA IR-310-RM User Manual

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
Figure 4-4: Relay output section

4.2.4 Communication Settings Section

This section can set the software Modbus Net ID and baud rate of the COM port.
Please reset the module to make the change effective.
The "Curr. ID" and "Curr. Baud" represent the current Modbus Net ID and current baud
rate of the IR-310-RM.
Figure 4-5: Communication settings section

4.2.5 Sequential Action for Relays Section

To enable/disable the sequential mode, please refer to previous section 2.8 to adjust
the DIP switch. This section shows current state of the sequential mode and time
interval (ms) for sequential action of relays after clicking the get buttons. The range of
the time interval is 0 to 65535 ms.
Figure 4-6: Settings of sequential relay action.
IR-310-RM, IR Controlled 10-ch High Power Relay Module (Ver. 1.1, Jul/02/2013) 24