Table of Contents
Advertisement
4.6 Description of screen messages
Message
ALL LOCK
PRESET & FILE LOCK
MENU → OFF
NO OPERATION
ENTER CORRECT PASSWORD
STORE DATA
CLEAR DATA
CHANGE BATTERY
WARNING:
FAN STOPPED!!
<POWER OFF PLEASE>
This message will appear if you make an attempt to change preset data (WIDTH, HEIGHT, etc.)
or do the switching between files (FILE1, FILE2, etc.) when "MENU 5 <LOCK> → (ALL
LOCK)" is displayed on the top of the MENU 5 screen that is selected using the MENU/ENT
switch.
To cope with it, enter the password on MENU 5, select UNLOCK and change data.
This message will appear if you make an attempt to change preset data (WIDTH, HEIGHT, etc.)
when "MENU 5 <LOCK> → (PRE8 FILE)" is displayed on the top of the MENU 5 screen that
is selected using the MENU/ENT switch.
To cope with it, enter the password on MENU 5, select UNLOCK and change data.
This message will appear if the "PRE" switch on the front panel is pressed when a menu is
displayed.
When a menu is displayed, no preset data can be changed. Exit from the menu by pressing the
ESC button before performing any operation.
This message will appear if misoperations are performed (for example, APERTURE is turned on
when SD signal is YPbPr-input.) or if there is no relevant function (for example, the 4:3 scan
mode is selected and the NORMAL/U-SCAN switch is operated when HD signal is monitored.).
This message will appear if the preset password disagrees with the entered password when the
LOCK state is displayed as <ALL LOCK> or <PRE & FILE> on the MENU 5 screen that is
selected using the MENU/ENT switch.
With CHANGE PRESET selected using the PRE switch, if the MENU/ENT switch is pressed
after any preset data is changed, the changed data will be written into memory. Also, if the
changed data is discarded by pressing the ESC switch before the MENU/ENT switch is pressed,
"CLEAR DATA" will blink three times instead of "STORE DATA".
The mark CHANGE BATTERY will appear (at power-on) if the voltage of the lithium battery
built into the VIDEO PROCESS BOARD that backs up data becomes insufficient. If this message
is displayed, contact the nearest Ikegami dealer.
This warning will appear if a stop of either the rear FAN or the internal FAN is detected.
The power pilot lamp on the front panel blinks eight times in two seconds and remains off for one
second repeatedly at the same time this warning is issued. This warning is displayed for two
minutes.
If the power supply is not turned off during this period, the protection circuit will work to shut off
the high voltage output, video output, etc.
If this warning is given, turn off the power and contact the nearest Ikegami dealer.
36
Description
Advertisement
Table of Contents
