TATU PD PLUS Operator's Manual page 93

6. Adjustments and operations
Hitching and unhitching the PCA
To hitch the front equipment (blade and bucket):
1. Use the articulator (D). Slowly move the front cylinder (A) to facilitate hitching.
2. Carry out the steps on reverse order for unhitching.
Gauge adjustment - PD, PCA and PCA PLUS
For a better performance of the front loader, carefully observe the instructions below:
- The bolt (A) adjustment must allow a total articulation of the front axle.
D D
1. After assembling the equipment, check if the front
tires are free to move, steering the wheel totally on
both sides. If necessary, adjust the gauge.
2. If it is necessary, change the turning radius of the
front axle by the adjusting bolt (A) and nut.
A A
NOTE
PD / PCA / PCA PLUS - Rev. 01 - Jun/22
91