Table of Contents
Advertisement
6. Adjustments and operations
Hitching and unhitching the PCA
2. Slightly move the front cylinders (A) until it is possible to move the lever (B) to free
the locking pins (C) and then drive the tractor on reverse gear until the hitching is
free;
3. Place the optional parts that are going to be used on hitching position and approach
them to the tractor slowly, seeking to hitch them on a correct position;
4. Finishing the hitching using the locking pins (C) and holes, free the lever (B) so that
the pins (C) get in position and the optional parts are hitched. On this operation, it
may be necessary to activate the front cylinder to facilitate hitching the pins;
5. The set will be easily hitched if it does not move during offseason.
Carry out the steps in reverse order for unhitching and follow the orientation below:
1. Relief the control valve pressure and activate the joystick a couple of times when
the engine is turned off;
2. Clean the male and female quick couplers using a cloth. Do not use cotton waste.
90
PD / PCA / PCA PLUS - Rev. 01 - Jun/22
C
C
A
A
B
B
Advertisement
Table of Contents
