TATU PD PLUS Operator's Manual page 112

7. Optional
SAB accessory assembly - PD
1. The SAB must be assembled after the adjusting support of the moving part of the
front loader is removed.
2. Couple the SAB (A) to the moving support (B) using an axle and cotter pin (C).
3. Couple the pressure hoses (D) on the safety valve and the return valve (E) on the
SAB cylinder and on the female quick coupler locked on the moving support.
4. The extension (F) must be positioned as shown on the illustration below.
- This equipment has a lifting cylinder that works when there is any failure on the cylinder
or on the hydraulic hoses to prevent the cylinder movement and thus avoiding that
the load drops to keep the operator, the equipment and any possible people that is
passing by safe.
110
PD / PCA / PCA PLUS - Rev. 01 - Jun/22
F
D
E
C
B
NOTE
A
Safety valve Safety valve
detail detail
F