Table of Contents
Advertisement
8. Maintenance
Equipment maintenance
- Check the tightening of the bolts and nuts daily, as well as all pins and cotter pins.
Carry out a general inspection on all components.
- During offseason wash the equipment, repair any damaged paintwork and lubricate
all grease fittings.
- Brake the equipment, lower it to the ground, shut down the tractor engine and remove
the tractor key before carrying out any maintenance service on your equipment.
- Do not make any repairs on the hydraulic system when it is pressurized or when the
cylinders are under load. A serious accident may result from this unsafe act.
- It is necessary to plan the maintenance and repairs to keep the equipment on safe
conditions.
- Check wear occurence on all moving parts. Replace any part, if necessary.
- Always use eye protection when operating the equipment.
- Replace the missing or damaged safety decals. Marchesan supplies these decals,
upon request and indication of their respective serial numbers. The operator must know the
need and importance to keep the decals in the proper place and in good conditions. The
operator also have to know the need to follow the instructions, as the lack of safety may
increase the risk of accidents.
- Always store the equipment on a dry place, protected from the rain and sunlight.
- Use TATU original parts only.
- Do not use chemical detergents to clean the equipment, as they may damage the
paintwork.
- When any component is disassembled and is not going to be used anymore, send
that part to a company that could recycle it and that respects the local law to avoid
causing damages to the environment.
124
PD / PCA / PCA PLUS - Rev. 01 - Jun/22
NOTE
Advertisement
Table of Contents
