Table of Contents
Advertisement
2)
DURING STORAGE
Start engine and move the machine and work
equipment once a month and apply lubrication to
each part.
Check the level of engine oil and coolant and
fill if required when starting engine.
Clean the anticorrosive on the piston rod of
cylinder.
Operate the machine such as traveling, swing
and work equipment operation to make sure
enough
lubrication
components.
3)
AFTER STORAGE
Carry out the following procedure when taking out
of a long time storage.
(1)
Wipe off the anticorrosive lubricant on the
hydraulic piston rod.
(2)
Completely fill fuel tank, lubricate and add oil.
(3)
When storage period is 6 months over
If the machine stock period is over 6 months,
carry out the following procedure.
This procedure is to drain condensation water
for the swing reduction gear durability.
Remove the drain port plug and drain the
water until the gear oil comes out and then
tighten the drain plug.
Refer to the service instruction, section 6 for
the drain plug location.
If the machine is stored without carrying out
the monthly lubricating operation, consult
your Hyundai dealer for service.
of
all
functional
4-24
Lubricating operation
once a month
D11074OP01
Advertisement
Table of Contents
