Table of Contents
Advertisement
3)
EMERGENCY ENGINE STARTING CONNECTOR
A
CN-92
B
11073CD46
4)
SAFETY LEVER
Unlock
Lock
RD21073CD45
5)
TRAVEL LEVER
21073CD46
6)
TRAVEL PEDAL
21073CD46A
7)
SEAT AND CONSOLE BOX ADJUST LEVER
Adjust lever
21073CD47
(1)
If the CPU controller is removed, the engine does not start.
(2)
Before starting the engine, connect the connector CN-92 A with B.
Do not connect these connectors when the CPU is not removed.
(1)
All control levers and pedals are disabled from operation by locating
the lever to lock position as shown.
Be sure to lower the lever to LOCK position when leaving from
operator's seat.
(2)
By pull lever to UNLOCK position, machine is operational.
Do not use the safety lever for handle when getting on or off the
machine.
(1)
This lever is mounted on travel pedal and used for traveling by hand.
The operation principle is same as the travel pedal.
(2)
Refer to traveling of the machine in chapter 4 for details.
(1)
This pedal is used to move the machine forward or backward.
(2)
If left side pedal is pressed, left track will move.
If right side pedal is pressed, right track will move.
(3)
Refer to traveling of machine in chapter 4 for details.
(1)
This lever is used to move the seat and console box to fit the contours
of the operator's body.
(2)
Pull the lever to adjust forward or backward over 170mm(6.7").
3-13
Advertisement
Table of Contents
