Hyundai Robex 130 SMART Operator's Manual page 74

3) STARTING ENGINE IN COLD WEATHER
Sound horn to warn surroundings after
checking if there are obstacles in the area.
Replace the engine oil and fuel referring to
recommended oils at page 2-16.
Fill the anti-freeze solution to the coolant as
required.
Check if all the levers are on the neutral position.
(1)
(2) Turn the starting switch to ON position, and wait
the preheat pilot lamp OFF.
Start the engine by turning the starting switch to
(3)
the START position after the preheat pilot lamp
OFF.
If the engine does not start, allow the starter
to cool for about 2 minutes before attempting
to start the engine again.
Release the starting switch immediately after
(4)
starting engine.
The operation for the warming up machine is
(5)
automatic.
4) INSPECTION AFTER ENGINE START
Inspect and confirm the following after engine
starts.
(1) Is the level gauge of hydraulic oil tank in the
normal level?
(2) Are there leakages of oil or water?
(3) Are all the warning lamps OFF(1-7)?
(4)
Is the indicator of engine coolant temperature
gauge(8) and hydraulic oil temperature gauge(9)
in the green zone?
(5) Is the engine sound and the color of exhaust gas
normal?
(6)
Are the sound and vibration normal?
Do not increase engine speed quickly after
starting, it can damage engine or
turbocharger.
If there are problems in the control panel,
stop the engine immediately and correct
problem as required.
START
1
2
3
4
5
4-4
ON
OFF
11074OP02
9
8
7
6
21074OP03B