Table of Contents
Advertisement
(3) Auto Decel
11073CD22
(4)
Work mode switch
D11073CD23
(5)
Travel speed control switch
21073CD24
(6)
Buzzer stop switch
21073CD25
(7)
Select switch
21073CD25A
This switch is used to actuate or cancel the auto deceleration
function.
When the switch actuated and all control levers and pedals are
at neutral position, engine speed will be lowered automatically
to save fuel consumption.
Light ON : Auto deceleration function is selected.
Light OFF : Auto deceleration function is cancelled so that the
engine speed increased to previous setting value. Operating the
auto deceleration function makes the decel indicating lamp
on the LCD panel ON.
This switch is to select the machine operation mode, which
shifts from general operation mode to heavy operation mode
and breaker mode in a raw by pressing the switch.
: Heavy duty work mode
: Breaker operation mode
Refer to the page 4-7 for details.
This switch is to control the travel speed which is changed to
high speed(Rabbit mark) by pressing the switch and low
speed(Turtle mark) by pressing it again.
When the starting switch is turned ON first, normally the alarm
buzzer sounds for 2 seconds during lamp check operation.
The red lamp lights ON and the buzzer sounds when the
machine has a problem.
In this case, press this switch and buzzer stops, but the red
lamp lights until the problem is cleared.
This switch is used to select the monitor display function.
Refer to the page 4-11 for details.
If the switch is pressed for 3 seconds in time display mode, it
moves to time adjusting function, and you can adjust the time
as below.
Hour by auto decel(
Minute by buzzer stop(
After time set, the switch is pressed, it returns to clock display.
3-8
)switch
) switch.
Advertisement
Table of Contents
