Table of Contents
Advertisement
2)
TRAVELING ON A SLOPE
(1)
Make sure that the travel lever is properly
maneuvered by confirming the travel motor is in
the right location.
(2)
Lower the bucket 20 to 30cm(1ft) to the ground
so that it can be used as a brake in an
emergency.
(3)
If the machine starts to slide or loses stability,
lower the bucket immediately and brake the
machine.
(4)
When parking on a slope, use the bucket as a
brake and place blocks behind the tracks to
prevent sliding.
Machine cannot travel effectively on a slope
when the oil temperature is low. Do the
warming-up operation when it is going to
travel on a slope.
Be careful when working on slopes. It may
cause the machine to lose its balance and
turn over.
Be sure to keep the travel speed switch on
the LOW(Turtle mark) while traveling on a
slope.
3)
TRAVELING ON SOFT GROUND
If possible, avoid to operate on soft ground.
Move forward as far as machine can move.
(1)
(2)
Take care not to go beyond the depth where
towing is impossible on soft ground.
(3)
When driving becomes impossible, lower bucket
and use boom and arm to pull the machine.
Operate boom, arm, and travel lever at the same
time to avoid the machine sinking.
20~30cm(1ft)
4-14
Travel motor
Travel motor
D11074OP26
90 ~ 110
D11074OP27
Advertisement
Table of Contents
