Table of Contents
Advertisement
3)
SEA SHORE OPERATION
(1)
Prevent ingress of salt by securely tightening
plugs, cocks and bolts of each part.
(2)
Wash machine after operation to remove salt
residue.
Pay special attention to electrical parts and
hydraulic cylinders to prevent corrosion.
(3)
Inspection and lubrication must be carried out
more frequently.
Supply sufficient grease to replace all old grease
in bearings which have been submerged in
water for a long time.
4)
OPERATION IN MUD, WATER OR RAIN
WORK SITES
(1)
Perform a walk around inspection to check for
any loose fittings, obvious damage to the
machine or any fluid leakage.
(2)
After completing operations, clean mud, rocks or
debris from the machine. Inspect for damage,
cracked welds or loosened parts.
(3)
Perform all daily lubrication and service.
(4)
If the operations were in salt water or other
corrosive materials, make sure to flush the
affected equipment with fresh water.
5)
OPERATION IN ROCKY WORK SITES
(1)
Check for damage to the undercarriage and for
looseness, flaws, wear and damage in bolts and
nut.
(2)
Loosen the track tension a little when working in
such areas.
(3)
Do not turn the undercarriage directly over the
sharp edge rock.
4-21
Advertisement
Table of Contents
