Hyundai Robex 130 SMART Operator's Manual page 136

3) STARTING THE ENGINE WITH A BOOSTER CABLE
Keep following order when you are going to start
engine using booster cable.
(1)
Connection of booster cable
Use the same capacity of battery for starting.
Make sure that the starting switches of the
normal machine and trouble machine are both
at the OFF position.
Connect the red terminal of booster cable to the
battery (+) terminal between exhausted and
new battery.
Connect the black terminal of the booster cable
between new battery (-) terminal and chassis of
trouble machine.
Keep firmly all connection, the spark will be
caused when connecting finally.
Starting the engine
(2)
Starting the engine of the normal machine and
keep it to run at high idle.
Start engine of the trouble machine with starting
switch.
If you can not start it by one time, restart the
engine after 2 minutes.
(3) Taking off the booster cable
Take off the booster cable(black).
Take off the booster cable(red) connected to the
(+) terminal.
Run engine with high idle until charging the
exhausted battery by alternator, fully.
Explosive gas is generated while using the
battery or charging it. Keep away flame and
be careful not to cause the spark.
Charge the battery in the well ventilated
place.
Place the machine on the earth or concrete.
Avoid charging the machine on the steel
plate.
Do not connect (+) terminal and (-) terminal
when connecting booster cable because it
will be shorted.
Connection of booster cable
Normal(New)
machine
To chassis of trouble machine
Connection order :
START
Disconnection of booster cable
Normal(New)
machine
To chassis of trouble machine
Disconnection order :
6-39
Red
Trouble(Exhausted)
machine
Black
13036MI33
ON
OFF
21076MA29
Red
Trouble(Exhausted)
machine
Black
13036MI33