Boot Parameter Definitions - Oracle Netra Server X5-2 Installation Manual

Flags
Target Name
Console Device
Console Baudrate : 115200
Other
[Acme Boot]: ?
?
@
p
c
v
r
s

Boot Parameter Definitions

The system displays all boot parameters when you configure them after a boot interrupt. The
system hides some boot parameters from the ACLI so that you do not attempt to configure
them. If changed improperly, these parameters can cause the system to sop responding.
The following table defines each of the parameters that the system displays when you
perform configuration after a boot interrupt.
Boot Parameter
Boot File
IP Address
VLAN
Netmask
Gateway
IPv6 address
IPv6 Gateway
Host IP
FTP Username
FTP password
Flags
Target Name
: 0x00000040
: ORACLE
: COM1
:
- print this list
- boot (load and go)
- print boot params
- change boot params
- print boot logo with version
- reboot
- show license information
Description
The name and path of the software image you are booting. Include
the absolute path for a local boot from the local /boot volume and for a
net boot when a path on the FTP server is needed.
IP address of wancom0.
VLAN of management network over which this address is accessed.
Note: VLANs over management interfaces are not supported on the
Acme Packet 4600, Acme Packet 3900, and Acme Packet 6xxx.
Netmask portion of the wancom0 IP Address.
Network gateway that this wancom0 interface uses.
Version 6 IP address/mask of wancom0. Configure the mask as a
forslash (/) after the address followed by the mask in number of bits.
Version 6 network gateway that this wancom0 interface uses.
IP Address of FTP server from which to download and execute a
software image.
FTP server username
FTP server password
Codes that signal the system from where to boot. Also signals the
system about which file to use in the booting process. This sequence
always starts with 0x (these flags are hexadecimal).
Name of the Oracle Communications Session Border Controller as it
appears in the system prompt. For example, ORACLE> or ORACLE#.
You need to know the target name if you are setting up an HA node.
This name must be unique among Oracle Communications Session
Border Controllers in your network. This name can be 63 characters
or less.
Chapter 8
Boot Parameters
8-3