Oracle Netra Server X5-2 Installation Manual page 38

Disable C6 Reporting. (Navigation: Advanced / CPU Power Management
e.
Configuration, CPU C6 report)
Change Energy Performance to Performance. For example, set
f.
"ENERY_PERF_BIAS_CFG" mode to "PERF". (Navigation: Advanced / CPU
Power Management Configuration, Energy Performance)
To decrease boot up time, Oracle recommends disabling Intel PXE Boot Agent
g.
for both onboard and NIC ethernet ports. Press F2 and navigate to Advanced,
Network Stack Configuration. Then disable IPv4 PXE support.
Note:
PXE boot is not supported in this release.
Reboot the server.
h.
Initialize the Hard Disk Drive.
4.
Open the ILOM remote system console to observe the system's boot cycle,
a.
and interrupt the boot cycle to enter the MegaRAID configuration utility.
Figure 4-1 Selecting RAID Configuration
Navigate the utility to establish your virtual drive's operation, initially including
b.
the Configure action.
Chapter 4
4-2