Oracle Netra Server X5-2 Installation Manual page 137

• In the ACLI configure terminal menu, type bootparam and press <Enter> to being
displaying the list of boot parameters.
Scroll through the boot parameters by pressing <Enter>. Stop when you reach the file
name boot parameter.
The following example uses the filenames /boot/nnSCZ720m5.64.bz and /
boot/nnSCZ730.64.bz.
ORACLE-2# configure terminal
ORACLE-2(configure)# bootparam
'.' = clear field; '-' = go to previous field;
boot device
processor number
host name
file name
As shown above, type the new Release file name next to the previous one, including
the path. Press <Enter> to continue scrolling through the boot parameters.
Reboot ORACLE-2.
After ORACLE-2 has completed the boot process, use the verify-config command to
5.
confirm that the configuration has been upgraded properly.
ORACLE-2# verify-config
Confirm the ORACLE-2 is running the new boot image using the show version
6.
command.
ORACLE-2# show version
Acme Packet 4600 SCZ7.3.0
Build Date=09/09/15
Use the show health command to confirm that ORACLE-2 is the standby system.
7.
As you did for ORACLE-2, upload the OCSBC software image file and stage three
8.
bootloader to the /boot directory using an SFTP client. (See the instructions on updating
the Stage 3 Bootloader.)
As you did for ORACLE-2, configure the boot parameters on ORACLE-1 to boot from the
9.
new software image. Then reboot ORACLE-1.
ORACLE-1# reboot
--------------------------------------------------------
WARNING: you are about to reboot this SD!
--------------------------------------------------------
Reboot this SD [y/n]?: y
Rebooting ORACLE-1 causes ORACLE-2 to become the active system in the HA node.
When ORACLE-1 is finished rebooting, use the show health command to confirm that it
10.
is in the standby state.
: eth0
: 0
: boothost
: /boot/nnSCZ720m5.64.bz /boot/nnSCZ730.64.bz
Chapter 12
HA Upgrade
^D = quit
12-9