Oracle Netra Server X5-2 Installation Manual page 62

wancom0
a.
wancom1
b.
wancom2
c.
spare
d.
s0p0
e.
s1p0
f.
s0p1
g.
s1p1
h.
Click New, Virtual Machine
5.
Hyper-V displays the introductory page of the New Virtual Machine Wizard.
Click Next.
6.
Hyper-V advances through the New Virtual Machine Wizard pages each time you click
Next. The wizard allows you to go back to the Previous page, Cancel the wizard, or
Finish the wizard with the respective buttons. Your procedure through the wizard may
vary, depending on your infrastructure and intent.
Enter or select at least the following as you progress through the wizard.
7.
Type a name for your VM in the Name field.
a.
Select Generation 1 as your machine type.
b.
Assign the desired memory.
c.
Click Next, skipping the Configure Networking dialog. You add networks later in the
d.
process.
Connect to the Virtual Hard Disk you downloaded by selecting the Use an existing
e.
virtual hard disk radio button and browsing to your .vhd file.
Finish
f.
The Hyper-V Manager returns to the main dialog, displaying your new machine in the
Virtual Machine list.
Right click the VM.
8.
The Hyper-V Manager displays a pop-up menu.
Click Settings ....
9.
The Hyper-V Manager displays the Settings dialog for your Virtual Machine displaying
the Add Hardware controls in the right-hand pane.
Select Legacy Network Adapter and click the Add button.
10.
The Hyper-V Manager displays the Legacy Network Adapter dialog.
Select wancom0 you configured for your Virtual Machine from the drop-down listbox and
11.
click the Apply, then the OK buttons. Repeat this step for wancom1 and wancom2 if you
are using these interfaces.
The Hyper-V Manager returns to the initial Settings dialog and adds this adapter to your
machine's component list in the left-side pane. Only configure wancom0, wancom1 and
wancom2 as Legacy Network Adapters.
Select Network Adapter and click the Add button.
12.
The Hyper-V Manager displays the Network Adapter dialog.
Chapter 6
Create and Deploy on Hyper-V®
6-9