Windows - Suzuki VITARA Series Manual

1) With the ignition mode "ON" or the igni-
tion switch in "ON" position, close all
the doors and turn the lock knob (1) on
the driver's door in the unlocking direc-
tion (2) (rearward). Turn the knob on
the lighting control lever to "OFF" posi-
tion (5).
NOTE:
All operations included in the following
Step 2) and 3) must be completed within
15 seconds.
2) Turn the knob on the lighting control
lever to the position (6) and then to
"OFF" position (5). Repeat this opera-
tion 4 times with the control lever finally
set to "OFF" position.
3) Push the lock end (3) (forward end) of
the power door lock switch (4) to lock
the doors, and then the unlock end (2)
(backward end) to unlock the doors.
Repeat these operations 3 times and
finally push the lock end of the switch.
Every time you perform the series of the
above steps, the state of the theft deterrent
alarm system changes from the currently
selected one to the other. You can check
whether the system is enabled or disabled
by the number of interior buzzer beeps at
the end of the procedure as follows.
System state Number of beeps
Disabled
(Mode A)
Enabled
(Mode D)
NOTE:
• You cannot disable the theft deterrent
alarm system while it is in the armed
condition.
• If you fail to complete the operations in
Step 2) and 3) within 15 seconds, per-
form the procedure again from the
beginning.
• Check that all doors are closed when
performing the above procedure.
NOTE:
You can also switch the theft deterrent
alarm system from the enabled state to the
disabled state, and vice versa, via the
information display setting mode. For
details on how to use the information dis-
play, refer to "Information display" in
"BEFORE DRIVING" section.

Windows

Manual window control
(if equipped)
Once
4 times
Raise or lower the door windows by turning
the handle located on the door panel.
BEFORE DRIVING
60G010A
2-20