Suzuki VITARA Series Manual page 634

For countries, in which the revised edition is applicable after the third edition of UN Regulation
No.10 has been enacted.
Installation of Radio Frequency (RF) Transmitting Equipment
Your vehicle is conformed to the revised edition since the third edition of UN Regulation No.10.
When you intend to use RF transmitting equipment in your vehicle, we strongly recommend that you select the equipment which
conforms to applicable rules or regulations in your country, and consult your SUZUKI dealer or qualified service technician for advice.
Table : Installing and the use of the on-board RF transmitter equipment
Frequency bands (MHz)
144-146
430-440
1200-1300
(1) Front
(2) Antenna installation position: Front left of roof
(3) Antenna installation position: Front right of roof
*The illustration is example of hatchback vehicle.
Specific conditions for installation
NOTE:
1) Antenna cable shall be routed as far as possible from the vehicle electrical and electronic systems and wiring in the vehicle.
2) Power cable of transmitter shall be properly connected to lead-acid battery on the vehicle.
Before using your vehicle, check if there is no interference to all electrical devices on your vehicle for both Standby mode
and Transmitting mode of the RF transmitting equipment.
Amateur band
Amateur band
Amateur band
NOTICE
Antenna position at vehicle*
(3)
(1)
(2)
54P0401201
Maximum output power (W)
50
50
10