Windows - Suzuki Ciaz Owner's Manual

BEFORE DRIVING
NOTE:
• Even after the alarm has stopped, if you
lock the doors using the keyless entry
system transmitter or keyless push start
system remote controller, the security
system will be rearmed.
• If you disconnect the battery while the
security system is in the armed condition
or the alarm is actually in operation, the
alarm will be re-triggered when the bat-
tery is then reconnected.
• Even after the alarm has stopped at the
end of the predetermined operation time,
it will be triggered again if any of the
doors, trunk or engine hood is opened,
or the warning may be triggered if the
vehicle feels a shock (if the shock sen-
sor is in the enabled state), without dis-
arming the security system.
Checking whether the alarm has been
triggered during parking
If the alarm was triggered and you then turn
the ignition switch to "ON" position or the
ignition mode is "ON", the security system
indicator will blink rapidly for about 8 sec-
onds and a buzzer will beep 4 times during
this period. If this happens, check whether
the vehicle has been broken into while you
were away from it.
2-15
Security system indication
• If any of the doors or trunk are opened
without unlocking by the keyless entry
system transmitter or keyless push start
system remote controller, all turn signal
lights start to blink and the interior buzzer
beeps intermittently. After 5 seconds, the
siren will sound for about 27.5 seconds.
The security system indicator continues to
blink during this time.
• If the engine hood is opened, all turn sig-
nal lights blink, and the siren sounds for
about 27.5 seconds. The security system
indicator continues to blink during this
time.
• If the shock sensor is in the enabled state
and the vehicle feels a shock higher than
the pre-warning sensitivity, the siren
sounds for about 2 seconds (pre-warn-
ing). If the vehicle feels a shock higher
than the full blast warning sensitivity, siren
will sound for about 4.5 seconds (full blast
warning). The security system indicator
continues to blink during this time.
NOTE:
If you set the full blast warning sensitivity
higher than the pre-warning sensitivity in
the setting mode of the information display,
or the vehicle feels such shock as to be
able to trigger the full blast warning, the full
blast warning will be triggered preferen-
tially. In this case, the pre-warning will not
be triggered.

Windows

Electric Window Controls
The electric windows can only be operated
when the ignition switch is in the "ON"
position or the ignition mode is "ON".
Driver's side
EXAMPLE
(1)
(2)
(4)
79MH0213
The driver's door has a switch (1) to operate
the driver's window, and a switch (2) to oper-
ate the front passenger's window or there
are switches (3), (4), to operate the rear right
and left passenger windows, respectively.
79MH0-74E
(3)