Suzuki VITARA Series Manual page 273

OPERATING YOUR VEHICLE
Exceeding maximum speed
You can exceed the maximum speed tem-
porarily by quickly depressing the acceler-
ator pedal all the way down. While the
vehicle speed is exceeded, the speed indi-
cation (7) on the information display will
flash and the buzzer will sound briefly.
If the accelerator pedal is released to
return below the maximum speed, the
speed indication (7) will stop flashing and
then stay lit, and the function will restore.
NOTE:
• When you depress the accelerator pedal
slowly, the vehicle speed may not
exceed the maximum speed. If you wish
to exceed the maximum speed, depress
the accelerator pedal all the way down
quickly or push "CANCEL" switch (2) to
cancel the maximum speed temporarily.
• The speed indication (7) will also flash
and the buzzer will sound if the speed
limiter cannot prevent the vehicle from
exceeding the maximum speed in such
cases as when going down a steep hill,
or under excessive acceleration. In this
case, decelerate to return below the
maximum speed using the brake pedal.
3-75
Changing speed setting
Setting to the current speed
1) Push "CANCEL" switch (2).
2) Accelerate or decelerate to the desired
speed.
3) Push "SET –" switch (4) and turn on the
set indicator (6). The current vehicle
speed is set as the maximum speed.
Using "RES +" switch or "SET –" switch
To change to a faster speed, press repeat-
edly or hold push "RES +" switch (3).
To change to a slower speed, press
repeatedly or hold push "SET –" switch
(4).
NOTE:
• You can adjust the set speed by 1 km/h
or 1 mph by pushing "RES +" switch (3)
or "SET –" switch (4) quickly.
• You can adjust the set speed by 5 km/h or
5 mph by pushing and holding "RES +"
switch (3) or "SET –" switch (4).
• If the current vehicle speed exceeds the
maximum speed when changing to the
slower speed using "RES +" switch (3) or
"SET –" switch (4), the speed indication
(7) will flash and the buzzer will sound.
Cancelling speed limiter
• To cancel the speed limiter, push "CAN-
CEL" switch (2). The set indicator (6) will
go off.
• To resume the previously set speed,
push "RES +" switch (3) and turn on the
set indicator (6).
To turn off the speed limiter system, push
"LIMIT" switch (1) and check that limit indi-
cator (5) is off.
Also, you can turn off the speed limiter by
turning off the engine.
NOTE:
If you turn off the speed limiter system, the
previously set speed in the memory is
cleared. Set your speed again.