Suzuki VITARA Series Manual page 554

(2)
CAUTION
Do not touch the heat sink on the
back of the position light (2). The heat
sink may get hot, which may cause
burns.
EXAMPLE
(3)
(4)
53SB60704
(3) Removal
(4) Installation
To remove the bulb of the front turn signal
light (1) from the bulb holder, push in the
bulb and turn it counterclockwise. To install
a new bulb, push it in and turn it clockwise.
To remove and install the bulb of the front
position light (2), simply pull out or push in
the bulb.
(2)
(1)
61MM0B078
INSPECTION AND MAINTENANCE
Front fog light (if equipped)
For LED front fog light (if equipped), it is
recommended that you take your vehicle
to a SUZUKI dealer for light replacement
since special procedures are required.
1) Start the engine. Turn the steering
wheel to the opposite side of the fog
light to be replaced to replace the bulb
easily. Then turn off the engine or the
strong hybrid system.
(1)
2) Remove the clips (1) by prying them off
with a flat-bladed screwdriver as shown
in the illustration.
EXAMPLE
53SB7006
7-80