Suzuki VITARA Series Manual page 282

WARNING
• The lane departure prevention may
not be suitable for every situation.
Also, the system is not designed to
drive your vehicle automatically,
and the system is not a substitute
for your steering operation. Do not
rely excessively on the system and
always drive in a safe manner.
• For safety reasons, do not check
the operation of the system by
yourself.
NOTE:
• When the system detects a hands-free
operation for a certain time and the
detection is repeated, the interior buzzer
beeps to warn you of this state. As the
detection is repeated, the buzzer beeps
longer. While the buzzer beeping, steer-
ing operation or switching OFF of the
lane departure prevention
switch cannot stop the buzzer for a
while.
• When the lane departure prevention
function works for about 9 seconds, the
interior buzzer intermittently sounds to
warn you of this state until the function
stops the activation.
Operating conditions of the system
When all of the following conditions are
met, the system will activate.
• When the system is on
• When the vehicle speed is approxi-
mately 65 km/h (40 mph) or over
• When the dual sensor detects the lane
lines
• When width of the track lane is about
3 m (10 ft.) to 4 m (13 ft.)
When the system is activated and your
vehicle is about to depart from the lane
line, the system will assist the steering
operation.
NOTE:
Even when the steering operation is being
assisted, you can handle the steering
wheel by yourself.
ON/OFF
OPERATING YOUR VEHICLE
Lane departure prevention ON/OFF
switch
EXAMPLE
(1) Lane departure prevention ON/OFF
switch
(2) Lane departure prevention indication
(Standby state)
• To turn on the lane departure prevention,
pull the lane departure prevention ON/
OFF switch (1) toward you and turn on
the lane departure prevention indication
(2).
• To turn off the lane departure prevention,
pull the lane departure prevention ON/
OFF switch (1) toward you again and
turn off the lane departure prevention
indication (2).
(2)
(1)
53SB3080
3-84