Suzuki VITARA Series Manual page 145

BEFORE DRIVING
("Pedal op dsp" setting) (if equipped)
Display of "Accelerator and brake" is
selectable to indicate or not to indicate.
("Regen disp" setting) (if equipped)
You can choose that deceleration energy
regenerating indicator light comes on or
does not come on.
("Hill descent" setting) (if equipped)
Display of "Hill descent" is selectable to
indicate or not to indicate.
("Driving mode" setting) (if equipped)
Display of "Driving mode" is selectable to
indicate or not to indicate.
Sign recog.
(Traffic sign recognition setting)
(if equipped)
If you select "ON" the traffic sign recogni-
tion function can be activated. Refer to
"Traffic sign recognition" in the "OPERAT-
ING YOUR VEHICLE" section for details.
BSM setting (if equipped)
If you select "ON" the Blind Spot Monitor
(BSM) or Rear Cross Traffic Alert (RCTA)
can be activated. Refer to "Blind Spot Mon-
itor (BSM) (if equipped)" or "Rear Cross
Traffic Alert (RCTA) (if equipped)" in the
"OPERATING YOUR VEHICLE" section
for details.
2-119
Default
(Initialization setting)
If you select "YES" and push the indicator
selector knob (3), all settings will be reini-
tialized.
Warning and indicator messages
The display shows warning and indicator
messages to let you know about certain
vehicle problems.
In some cases, the external or internal
buzzer may also sound at the same time to
alert you.
If warning and indicator messages appear
on the display, follow the messages.
Master warning indicator light
When the display shows warning and indi-
cator messages, the master warning indi-
cator light may also blink.
NOTE:
• When the problem that causes a mes-
sage to appear is corrected, the mes-
sage will disappear.
• If a message is displayed, and other
problems requiring a message occur, the
message for each of the problems will
be alternately displayed about every 5
seconds.
• When you push and hold the indicator
selector knob (3) for about 2 seconds
while a message is displayed, the mes-
sage will disappear temporarily. If the
problem that caused the message is not
corrected, the message will appear
again after 5 seconds. When you push
and hold the indicator selector knob (3)
for about 2 seconds while a message is
displayed, the message will disappear
temporarily. If the problem that caused
the message is not corrected, the mes-
sage will appear again after 5 seconds.
68PM00278