Suzuki VITARA Series Manual page 307

OPERATING YOUR VEHICLE
Changing speed temporarily
When the cruising speed is maintained,
you can temporarily accelerate or deceler-
ate.
To accelerate, depress the accelerator
pedal. When you take your foot off the
pedal, your vehicle will return to the set
speed.
To decelerate, depress the brake pedal.
The adaptive cruise control will be can-
celled and "SET" indicator (8) will disap-
pear. To resume the previously set speed,
push "RES +" switch (4) and turn on "SET"
indicator (8) again when vehicle speed is
above about 40 km/h (25 mph). The vehi-
cle will accelerate to the previously set
speed and maintain its speed.
3-109
Changing set speed
• Using the accelerator pedal
To reset at a faster set speed, accelerate to
the desired speed using the accelerator
pedal and push "SET –" switch (5). The new
speed will be maintained.
• Using the brake pedal
To reset at a slower set speed, decelerate
to the desired speed using the brake pedal
and push "SET –" switch (5). The new
speed will be maintained.
NOTE:
When the brake pedal is depressed, "SET"
indicator (8) disappears until you reset the
set speed.
• Using "RES +" switch or "SET –" switch
To reset at a faster set speed, press
repeatedly or hold push "RES +" switch
(4). The set speed will increase.
To reset at a slower set speed, press
repeatedly or hold push "SET –" switch (5).
The set speed will decrease.
NOTE:
• You can adjust the set speed by 1 km/h
(or 1 mph) by pushing "RES +" switch (4)
or "SET –" switch (5) quickly.
• You can adjust the set speed by 5 km/h
(or 5 mph) by pushing and holding "RES
+" switch (4) or "SET –" switch (5).
• While deceleration control or following
control is activated, the vehicle is not
accelerated even though resetting to
higher set speed by continuous pushing
"RES +" switch (4) is operated. However,
if the vehicle ahead disappears, the
vehicle is accelerated automatically to
the set speed.