Suzuki VITARA Series Manual page 314

Changing speed temporarily
When the cruising speed is maintained,
you can temporarily accelerate or deceler-
ate.
To accelerate, depress the accelerator
pedal. When you take your foot off the
pedal, your vehicle will return to the set
speed.
To decelerate, depress the brake pedal.
The adaptive cruise control with stop & go
will be cancelled and "SET" indicator (8)
will disappear. To resume the previously
set speed, operate "RES +" switch (4) as
follows.
• When there are vehicles ahead:
Push "RES +" switch and turn on "SET"
indicator again when vehicle speed is
above about 1 km/h (0.6 mph).
• When there are no vehicles ahead:
Push "RES +" switch and turn on "SET"
indicator again when vehicle speed is
above about 40 km/h (25 mph).
After the above setting, the vehicle will
accelerate to the previously set speed and
maintain its speed.
Changing set speed
• Using the accelerator pedal
To reset at a faster set speed, accelerate to
the desired speed using the accelerator
pedal and push "SET –" switch (5). The new
speed will be maintained.
• Using the brake pedal
To reset at a slower set speed, decelerate
to the desired speed using the brake pedal
and push "SET –" switch (5). The new
speed will be maintained.
NOTE:
When the brake pedal is depressed, "SET"
indicator (8) disappears until you reset the
set speed.
• Using "RES +" switch or "SET –" switch
To reset at a faster set speed, press
repeatedly or hold push "RES +" switch
(4). The set speed will increase.
To reset at a slower set speed, press
repeatedly or hold push "SET –" switch (5).
The set speed will decrease.
OPERATING YOUR VEHICLE
WARNING
• The vehicle also stops when vehi-
cles ahead stop. After the vehicle
stops, immediately press the brake.
When the brake is not depressed,
the buzzer emits a beeping sound,
and the adaptive cruise control
with stop & go is automatically
released approximately one sec-
ond afterwards at the same time as
a chime is emitted. There is a dan-
ger that the vehicle start traveling
due to vehicle creep. Immediately
press the brake pedal to stop the
vehicle.
• When the vehicle starts to stop due
to a vehicle ahead stopping, there
is a possibility that the vehicle
ahead cannot be detected depend-
ing on the conditions of the vehicle
ahead or of surrounding vehicles.
In these cases, operation of the
adaptive cruise control with stop &
go may be cancelled, making the
vehicle unable to stop automati-
cally. Always operate the vehicle
after confirming the surrounding
area.
(Continued)
3-116