Suzuki VITARA Series Manual page 69

BEFORE DRIVING
Seat belt inspection
EXAMPLE
Periodically check if the seat belts work
properly and are not damaged. Check the
webbing, buckles, latch plates, retractors,
anchorages and guide loops. Replace any
seat belts which do not work properly or
are damaged.
2-43
WARNING
Inspect all seat belt assemblies after
any collision. Any seat belt assembly
which was in use during a collision
(other than a very minor one) should
be replaced, even if damage to the
assembly is not obvious. Any seat
belt assembly even which was not in
use during a collision must be
replaced if the seat belt pretension-
ers were activated. The pretensioners
and the load limiter only function
once. In case they did not activate,
consult with SUZUKI dealer.
65D209S
Seat belt pretensioner system
and/or
Label
WARNING
This section describes your SUZUKI
vehicle's seat belt pretensioner sys-
tem. Read and follow all these
instructions carefully to minimize
your risk of severe injury or death.
To determine if your vehicle is equipped
with a seat belt pretensioner system at the
front or rear seating positions, check the
label on the seat belt at the bottom part. If
the letters "p" and/or "PRE" appear as illus-
trated, your vehicle is equipped with the
seat belt pretensioner system. You can use
the pretensioner seat belts in the same
manner as ordinary seat belts.
EXAMPLE
53SB2039