Safety Instructions; General; Installation; Operation And Maintenance - Mocon AMETEK Dansensor MAP Check 3 Vacuum User Manual

Dansensor MAP Check 3 Vacuum
®

Safety Instructions

Personnel operating and maintaining the device must be familiar with all aspects of its
operation and be proficient in maintenance.
Such personnel should review the following precautions to promote safety awareness.

General

Always refer to the manual before operating or maintaining the equipment.

Observe all WARNINGS, CAUTIONS and NOTES.

Do not open the device. In case of technical problems please contact your service provider.

Do not cover the machine with a cloth or piece of plastic to protect it from dust, as this

prevents free air circulation around the machine and might lead to overheating and errors
in the sensor read-out.
Do not expose the equipment to heavy moisture or heat and keep it away from direct

sunlight.
Never short circuit or remove safety devices.


Installation

To ensure the best installation with the least technical problems, please install equipment

as described in this manual.
Never install the equipment in explosive environments.

Always use correct fittings when connecting gas from the gas bottle.

Provide adequate space around the equipment for proper ventilation.

The units are Class 1 appliances and must be connected to an earthed mains connection.

It is the responsibility of the owner and operator(s) of the equipment, that the installation is

made in accordance with local rules and regulations.
When installing the equipment it is necessary to ensure proper ventilation in the room of

the installation in accordance with requirements from manufacturer.
The manufacturer cannot be held responsible for any damage caused by incorrect

installation of this equipment.

Operation and Maintenance

Be sure to disconnect electrical power and unplug the unit before performing any cleaning

or maintenance.
All panels and protective guards must be in place before operating the equipment.

When operating or maintaining the equipment always obey the relevant rules and

regulations for workers safety.
Repair or replace damaged power cords immediately.

Never block gas outlets.

EN User Guide 9
P/N 320598-G
11/2019