Diagnostics Menu - Mocon AMETEK Dansensor MAP Check 3 Vacuum User Manual

Dansensor MAP Check 3 Vacuum
®

Diagnostics menu

Selecting Diagnostics menu from the Main menu will take you to the device's Diagnostics
pages.
The Diagnostics section consists of 3 pages. Use the arrow keys in the headline area to go to
next or previous page:
The first page shows the internal parameters of the device. These are values such as the

device's internal temperature, the pressure in the sensors, the sensor's conditions, serial
numbers for main components, day/hour counters, time to calibration, and software
versions, etc. The parameters can only be read and not changed.
The second page holds a menu from where you can

- open the Diagnostics error log and Diagnostics events log pages.
- start a test measuring on the Cal. Gas or Buffer Gas inlets.
The measure functions are normally used for initial testing after installation on machine.
- start a System leak test.
The third page shows the state of the valves, the Vac and Gas signals, and the Ready,

Warning and Alarm relays.
EN User Guide 59
P/N 320598-G
11/2019