Mocon AMETEK Dansensor MAP Check 3 Vacuum User Manual page 43

Dansensor MAP Check 3 Vacuum
®
No. Type
52 Error
54 Warning
55 Warning
58 Error
59 Error
60 Error
69 Error
70 Error
71 Error
72 Error
73 Error
74 Error
75 Error
76 Warning
77 Error
79 Error
83 Warning
EN
Message
O sensor is disabled because of hardware fail.
2
Please call service.
Error in O sensor calibration data. Check if the gas
2
concentration and span is correct.
O sensor needs calibration. Measuring values may
2
not be valid.
Fan speed too low, check if fan is functional
Error in fan parameters, running fan at full speed.
Temperature sensor not calibrated. Device
temperature may not be valid.
Sample system clogged. Check hose for blockages
Illegal mixer setting: a 2-gas mixer is connected but
3-gas mixer is expected
Cannot establish connection to external mixer
Data log network dump failed: cannot connect to
server
Data log network dump failed: connection to server
was lost
Data log network dump failed: no ACK received
Data log network dump failed: wrong ACK received Check LAN
Mixer low pressure alarm on gas input
Error from slave mixer
Zr O cold-junction temperature too high. Possible
2
O sensor fan fault.
2
Ambient pressure value out of reasonable range.
Possible pressure sensor fault.
User Guide
User action
Contact service
Contact service
for sensor
calibration
Contact service
for sensor
calibration
Contact service
Contact service
Check cooling/
filters
If error persists,
contact service
User information
User information
User information
Check LAN
connection
Check LAN
connection
Check LAN
connection
connection
X User information
User information
Contact service
Check and clean
Air inlet/Sensor
gas/sample gas
outlets
If error persists,
contact service
P/N 320598-G
11/2019
41