System Leak Test - Mocon AMETEK Dansensor MAP Check 3 Vacuum User Manual

50 User Guide

System leak test

This test is used to verify system tightness in sensor and flow parts. A leak is fatal for
measurements and the test should therefore be done periodically or in case of strange
readings.
Apply vacuum to the device and stop the packaging machine.

Enter Diagnostics and go to page 2 and select System leak test in the menu.

A popup window will remind you to stop machine and to ensure that vacuum is applied.

Press Yes to continue or No to cancel.
The test will start with a short stabilizing period then a 1 minute measurement is

performed.
P/N 320598-G
11/2019
System leak test
Yes No
EN Dansensor MAP Check 3 Vacuum
®