Electrical Connections - Mocon AMETEK Dansensor MAP Check 3 Vacuum User Manual

Dansensor MAP Check 3 Vacuum
®

Electrical connections

Connect the power supply cable

(The power cable is delivered with the device).
See pin connections for the power connector in
Connect a 25-pole communication cable

appropriate port on the packaging machine. This cable is delivered with the device.
See cable specifications in
Connect a 9-pole serial cable

packaging machine - see
This cable is not delivered with the device.
Connect a 9-pole serial cable

the MAP Mix Provectus (option) - see
This cable is not delivered with the device.
Connect a LAN/Ethernet cable

your local area network. This cable is not delivered with the device.
NOTE! Use CAT6 cables for optimal noise immunity.

The USB connector (labelled

exporting/importing log data, device settings etc.
On "Stand-Alone" versions you can use the USB connector on the device front as well.
EN

between a power outlet and the "POWER" connector.
"Power connector" on page

from the "I/O CONTROL" connector to the
"I/O Cable" on page 24.

from the "COM1" connector to the appropriate port on the
"I/O signals for machine control" on page 27

from the "COM2" connector to the "COM1" connector on
"I/O signals for machine control" on page 27

from the LAN connector (labelled
) can be used for connecting a USB Memory stick
User Guide
24.
for details.
for details.
) to a connector on

for
P/N 320598-G
11/2019
23